Teeter Hang Ups ComforTrak Series Assembly Instructions Manual page 13

FIGURE 10
1
Front Ankle Bar Housing
FIGURE 11
1
1
Retainer Spring & Cable Loop
FIGURE 11A
FIGURE 11B
Step
Install the Front Ankle Bar Assembly
• With hole settings facing up, insert the Front Ankle Bar (EP-1045B) into the Front Ankle Bar
Housing (Figure 10). Pull up on the T-Pin Lock to allow the Front Ankle Bar to insert all the
way into the housing. Release the T-Pin to engage in the hole setting closest to the Front
Ankle Cups.
1
• From the reverse side, pull on the zip-tie to stretch the Retainer Spring and Cable Loop so
that they align with the holes in the back of the Front Ankle Bar Housing (Figure 11).
• Insert the Bolt (F5-1089) starting through the outer side of the housing in the following order:
hole, Retainer Spring and Cable Loop, hole (Figure 11).
• Tighten the Nut (H1-3007) using the 13mm Open Wrench (F5-1088) provided.
• Cut the long portion of the zip-tie with scissors (Figure 11A) so that it doesn't interfere with
the function of the Retainer Spring. Cover the open end with the End Cap (F5-1048)
(Figure 11B).
3
(continued)
! WARNING
Failure to assemble the T-Pin Ankle Lock System properly could
result in serious injury or death!