Teeter Hang Ups ComforTrak Series Assembly Instructions Manual page 19

FIGURE 23
Step 8
Depending on the model you have purchased, the items in this step will vary.
See "Which Model Do you Own?" (page 4) for more information.
Assemble the Tether to the Table Bed (EP-1300)
EP-560 & EP-560 Sport: use the Angle Tether (F5-1007)
EP-860, EP-960 & EP-970: use the EZ-Angle Tether (F5-1008)
• The Tether will come pre-assembled to the A-Frame.
• Unfold the adjustable Tether and clip it to the U-Bar on the underside of the Table Bed
(Figure 23).
• The EZ-Angle Tether has color coded angles to assist in varied angles of inversion for
your experience level:
20° / Gentle Inversion
Green stripe must show in the center of the sliding buckle.
40°/ Moderate Inversion
Orange stripe must show in the center of the sliding buckle.
60° / Intermediate Inversion
Red stripe must show in the center of the sliding buckle.
This is the angle when full decompression is realized.
90° / Advanced Inversion
Remove the tether strap clip from U-Bar to enable rotation to full inversion.