Teeter Hang Ups ComforTrak Series Assembly Instructions Manual page 10

FIGURE 5
EP-860, EP-960, EP-970 Models
FIGURE 6
FIGURE 6A
Step
Assemble the Handles to the Table Bed (EP-1300)
Bolts/Nuts may come pre-assembled in the Handles. Simply unscrew to remove.
EP-860, EP-960 & EP-970: Assemble the Stretch Max Handles (E6-1520)
• Assemble one side at a time. It does not matter which side (left / right) you start with.
• Using the 10/13mm Wrench (F5-1088), remove the Bolt, Nut and three Washers from where
the Spreader Arm meets the rear of the A-Frame (Figure 5). Discard the Bolt and Nut, but
keep one of the Washers.
• Place the corresponding Handle (left / right) over the outside edge of the Hinge Plate (refer
to Figure 6).
• Insert and loosely hand-tighten the three Allen Head Bolts ((F5-0071) through the Hinge
Plate into the handle (Figure 6).
• Position the lower part of the Handle between the Spreader Arm and the A-Frame leg.
Thread one Washer on the Bolt and insert from the inside of the A-Frame. Make sure the
Bolt goes through the A-Frame leg, Handle and Spreader Arm. Thread one Washer on the
end and secure with the Nut (Figure 6). Refer to Figure 6A for how the finished assembly of
this should look.
• Fully tighten all Bolts, using the Allen Wrench provided, being careful not to overtighten.
• Repeat on the other side.
2
(continued)