5Mm Allen Wrench - Teeter Hang Ups ComforTrak Series Assembly Instructions Manual

FIGURE 12
Center Bolt (1)
FIGURE 13
Upper Bolts/Nuts (2)
1
1
Bed Frame Extension - Loop
FIGURE 14
Step 4
Assemble the Table Bed (E6-1300) and Bed Frame Extension (E6-1380)
NOTE: This assembly will be referred to as Table Bed (E6-1300) for the remainder of the
Assembly Instructions.
• Locate the following items to assemble the Table Bed:
ComforTrak™ Bed - Upper Portion (E6-1300A)
Bed Frame Extension (E6-1380)
5mm Allen Wrench (IA-1149)
• Lay the ComforTrak™ Bed - Upper Portion (E6-1300A) face down on the floor.
• Place the ComforTrak™ Bed Frame (E6-1300) face down on top of the Upper Portion
and align the bolt holes.
• Reaching underneath, insert a Bolt in the center hole and hand-tighten with a Nut
(Figure 12).
• Reaching underneath, insert one of the remaining Bolts through one of the holes in the
Upper Portion and hold in place. Slide one of the Bed Frame Extension loops over the
Bolt and hand-tighten with a Nut (Figure 13).
• Repeat with remaining side (Figure 14).
• To fully tighten all three nuts to the bolts, insert the 5mm Allen Wrench (IA-1149) into
the Bolt heads and tighten the Nuts using the 10/13mm Wrench (F5-1088).
ComforTrak™ Bed Frame (E6-1300)
Bolts & Nuts (F1-1390)
10/13mm Wrench (F5-1088)