Teeter Hang Ups ComforTrak Series Assembly Instructions Manual page 17

FIGURE 21
1
3
2
1
Main Shaft
2
Main Shaft Housing
3
Height-Selector Locking Pin
FIGURE 22
1
2
1
Proper Resting Position
2
Crossbar
Step 7
Depending on the model you have purchased, the items in this step will vary.
See "Which Model Do you Own?" (page 4) for more information.
Insert the Main Shaft into the Table Bed
EP-560 and EP-860 models will use the Main Shaft with T-Pin Ankle Lock System (E6-1600)
EP-960 model will use the EZ-Reach Ratchet Ankle Lock System (E6-1630)
EP-970 model will use the Deluxe EZ-Reach Ratchet Ankle Lock System (NX-1630B)
• With the Height Adjustment Settings on the Main Shaft facing up, slide the end of the
Main Shaft into the Main Shaft Housing (Figure 21) on the Table Bed.
• Pull out the Height-Selector Locking Pin to allow the Main Shaft to slide in further and release
in the desired height setting. Refer to the Owner's Manual for more information on selecting
your height setting.
• The Main Shaft MUST REST against the Crossbar of the A-Frame (Figure 22).
NOTE: The Crossbar prevents the Table Bed from rotating forward when the user steps
on the Ankle Comfort Dial. If the Main Shaft does not rest on the Crossbar as shown in
Figure 23, then the Table Bed has been assembled backwards onto the A-Frame.
This MUST BE CORRECTED before use.