Screwdriver - Teeter Hang Ups ComforTrak Series Assembly Instructions Manual

FIGURE 7
FIGURE 7A
FIGURE 7B
Step 3
Depending on the model you have purchased, the items in this step will vary.
See "Which Model Do you Own?" (page 4) for more information.
EP-560 models & EP-860: Complete this step.
EP-560 Sport: Complete this step to use the standard Ankle Lock System. To use with the
EZ-Up Gravity Boots refer to either the ComforTrak DVD or the insert that can be found with
the Conversio Bar.
EP-960 & EP-970: Skip this step and proceed directly to Step 4.
Assemble the T-Pin Ankle Lock System onto the Main Shaft (E6-1600)
Install the Ankle Comfort Dial
• Slide the Ankle Comfort Dial Bar (IA-1119) with pre-assembled Ankle Comfort Dial into the
hole at the front base of the Main Shaft (Figure 7).
• The Ankle Comfort Dial is designed with a High and Low setting. Position the pre-assembled
Dial in the Low Setting (screw holes facing up) for ease of assembly. Slide the separate
Ankle Comfort Dial (IA-1118) onto the Ankle Comfort Dial Bar.
• Insert the Screw (IA-1123) (Figure 7A) and tighten with the Screwdriver (F5-1130) provided.
See Figure 7B for detailed view of Screw (IA-1123).
NOTE: Refer to the Owner's Manual for a complete description of the Ankle Comfort Dial
settings.