Teeter Hang Ups ComforTrak Series Assembly Instructions Manual page 16

FIGURE 19
FIGURE 19A
1
2
1
Roller Hinge Pivot Pin
2
Self-Locking Hook
FIGURE 20
1
Self-Locking Hook
2
Roller Hinge
Attach the Table Bed (E6-1300) to the A-Frame (E6-1100)
• Pick up the Table Bed, holding each side near the Roller Hinges, and stand in front of the
A-Frame where the Crossbar is located (refer to Figure 3 to determine A-Frame Front).
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates, one side at a time
(Figures 19 and 19A). With pressure, the Self-Locking Hooks will open to allow the Pivot Pin
into the slot, then automatically close over the Pivot Pin.
NOTE: You may need to push outward on the A-Frame in order for the 2nd Pivot Pin
to lock in place.
• Make sure that each Pivot Pin is seated at the base of the slot of the Hinge Plate (Figure 20),
that the Self-Locking Hooks have closed over both Pivot Pins, and that the Table
Bed rotates smoothly.
1
2
Step 6
Failure of the Self-Locking Hooks to close over both Roller Hinge
Pivot Pins is an indication of improper assembly and if not corrected
could result in serious injury or death!
! WARNING