Teeter Hang Ups ComforTrak Series Assembly Instructions Manual page 21

FIGURE 26
FIGURE 27
FIGURE 28
A B C
Adjusting the Roller Hinge Setting
Adjustments: Changing the Roller Hinge Setting
To adjust the Roller Hinge setting, you'll need to fully remove the Table Bed from the
A-Frame.
• Remove the Angle Tether from the U-Bar located on the underside of the Table Bed.
• Pull the Height-Selector Locking Pin and slide the Main Shaft in all the way to the last
hole setting.
• Release and engage the Pin in the storage setting.
• Rotate the Table Bed opposite from use until it has turned 180° and rests against
the Crossbar of the A-Frame (Figure 26).
• With palms up, reach under and around each Roller Hinge, using your thumbs to release
the Self-Locking Hooks over the Pivot Pin (Figure 27).
• Lift both sides of the Table Bed out of the A-Frame at the same time. TIP: Rest the head
of the Table Bed on the floor for quick adjustment. Unlock the Cam Locks for each Roller
Hinge. Change the Roller Hinges to the desired setting (A, B or C).
NOTE: Refer to the Owner's Manual for more information on finding your Roller Hinge
Setting.
• Re-lock the Cam Locks (Figure 28). Replace the Table Bed onto the A-Frame by lowering
the Roller Hinges into the hinge plates of the A-Frame.
• Rotate the Table Bed back to the use position and re-adjust the Main Shaft height settings
for use.