Broil Element - GE Profile PHB925SB1SS Technical Service Manual

Note: When reinstalling the sensor, use a small fl at-
blade screwdriver to push and guide the sensor wire
harness into the oven liner.
Note: Upon reassembly, ensure displaced insulation
around oven and components is returned to its
original position.

Broil Element

• The broil element will not work if the
temperature probe is plugged in.
• The broil element is located on the back wall of
the oven. The oven sensor must be removed to
access the broil element.
The broil element is rated at 3800 watts and has
an approximate resistance value of 15 Ω. When
energized, the broil element will draw approximately
15 amps.
To remove the broil element:
1. Remove the 1/4-in. hex-head screw that
attaches the sensor to the back of the oven
cavity. (See
Oven Temperature Sensor
2. Remove the four 1/4-in. hex-head screws that
hold the broiler to the oven cavity.
Broil Element
3. Carefully pull, then lower the broiler element
towards the front of the oven.
4. Disconnect the wires from the broiler element.
Note: Upon reassembly, ensure displaced insulation
around oven and components is returned to its
original position.
.)
– 37 –
Disconnect
Disconnect