Oven Light Assembly - GE Profile PHB925SB1SS Technical Service Manual

6. Lift the cooktop upward and over the hinge
pins and place it on the range as shown. (See
.)
Cooktop Assembly
Note: Insulation is wrapped around and under the
vent tube.
7. Remove the 1/4-in. hex-head screw that holds
the vent tube to the rear of the range.
8. Grasp the vent tube and its insulation and rotate
it approximately 40 degrees counterclockwise
and lift it from the range.
Caution:
1. When installing the vent tube, make sure the
inside of the vent tube is free of insulation.
2. Upon reassembly, ensure displaced insulation
around the oven vent tube is returned to its
original position.
Vent Tube
– 43 –

Oven Light Assembly

The oven is equipped with a halogen light assembly
located on the ceiling of the oven. The oven door
switch monitors the position of the oven door and
provides this information to the control board. The
control board operates the light relay located on the
control board. The light comes on when the door is
opened or when the oven is in a cooking cycle. The
oven light does not come on during self-cleaning or
if the Sabbath feature is set.
The light assembly consists of a removable light
cover, a light lens with halogen bulb and socket, and
wire harness.
Open the oven door and remove the two 1/4-in.
hex-head screws that attach the light assembly to
the oven ceiling.
The light assembly and wiring can then be pulled
down from the oven ceiling approximately 2 inches.
Note: When replacing the light assembly, cut the
wires and splice the new light assembly using
approved heat resistant connectors.
Note: Upon reassembly, ensure displaced insulation
around the wiring entry hole is returned to its
original position.