Cooktop Assembly; Warming Drawer Assembly - GE Profile PHB925SB1SS Technical Service Manual

Warming Drawer Assembly

To remove and replace the warming drawer
assembly:
Pull the drawer out until it stops. Lift the tab on the
left side and push the tab down on the right side
while pulling the drawer out.
To replace the warming drawer, place the drawer
rail in the guides and push the drawer in until it
stops.
Right Side Tab

Cooktop Assembly

The ceramic glass cooktop is sealed into the
cooktop frame and is not replaceable as a separate
part. The glass cooktop and frame come as a
complete assembly.
To remove the cooktop assembly:
1. Disconnect power to the range.
2. Remove the rear cover. (See
3. Disconnect the 3 wire harnesses and ground
wire that connect the induction module to the
range wiring.
.)
Rear Cover Removal
– 32 –
4. Disconnect the wire harness that connects the
warming zone to the range wiring.
5. Remove the 1/4-in. hex-head screw that
attaches the cooktop ground wire to the back of
the range.
6. Carefully push the cooktop side of the
disconnected wiring through the wire entry
opening in the back of the range.
Induction Module
Ground Wire
Warming Zone
Wire Harness
Cooktop
Linbus
Ground Wire
7. Open the oven door and remove the two 1/4-
in. hex-head screws that hold the front of the
cooktop to the range frame.
Note: The cooktop panel hinge slots rest on a hinge
pin mounted to each end plate.
Hinge Slot
Induction Module L2
Induction Module L1
End Plate
(Continued next page)