Door Switch
The oven utilizes a door switch located on the left
side of the door frame that is accessible from the
front. The oven door switch monitors the position of
the oven door and provides this information to the
oven's control board.
To remove the door switch:
1.
Disconnect power to the range.
2.
Pull the switch forward to locate the ends of two
spring clips (one on each side).
3.
Insert a small fl at-blade screwdriver on one
of two spring clips and depress the spring clip
while pulling the switch from the door frame.
4.
Insert the small fl at-blade screwdriver on the
other spring clip, depress the spring clip, and
continue pulling the switch from the door frame.
5.
Disconnect the door switch wire harness.
Oven Door Hinge Receiver
To remove the hinge receiver:
1.
Remove the side panel. (See
Note: If replacing the left side hinge receiver, it is
necessary to remove the air tunnel from the left
side. (See
Bake Element
2.
Remove the 1/4-in. hex-head screw that
attaches the lower aluminum plate to the range
frame. (See
Bake Element
3.
Move the lower aluminum plate to the left, then
tuck the insulation and remove the two T-20
screws that attach the hinge receiver to the
frame.
Note: Upon reassembly, ensure displaced insulation
around oven and components is returned to its
original position.
– 35 –
Side Panel Removal
.)
.)
Hinge
Receiver
.)