Table of Contents
Advertisement
appendix
PROBLEM
I have set <Object counting> to
<On> in <Setup>, but the green
box on the monitoring screen is
displayed bigger or smaller than
the image size of the passer-by.
I have set <Object counting> to
<Enable> in <Setup>, but the
green box is hardly displayed
or excessive on the monitoring
screen.
I couldn't see any threshold rule
or area coefficient rule on the
monitoring screen.
Cannot record into the SD memory
card.
SD memory indicator does not
turn on even when the SD memory
card is inserted.
SD memory card is inserted but
the camera does not operate
properly.
Cannot format the SD memory
card.
90_ appendix
Change the object size as appropriate in <Setup> - <Object counting>
on the moinitoring screen and check if the green box fits.
If the greenbox is hardly displayed, adjust the sensitivity to higer in
<Setup> - <Object counting>; if the green box is is excessive, adjust
the sensitivity to lower in <Setup> - <Object counting>.
Check if you have set <Overlay> to <Enable> in <Setup> - <Object
counting>.
Check if the memory card is defective.
Check if the write protection tab of the memory card is set to "Lock".
Check if the memory card is defective.
Check if the <Record> is checked in <Setup>
Record> menu.
Check if the memory card is inserted in the proper direction. Operation
of memory card that is formatted by other devices is not guaranteed
with this camera unit
Format the memory card again in <Setup>
menu.
Check if the write protection tab of the memory card is set to "Lock".
SOLUTION
<Event>
<Event>
<SD Card
<SD Card>
Advertisement
Table of Contents
