Table of Contents
Advertisement
Item
URL
IPv4
IPv6
Search
Auto Set
Manual Set
Exit
STATIC IP SETUP
Manual Network Setup
Run <IP Installer.exe> to display the camera search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
M
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
support this function.
1.
Select a camera in the search list.
Find the MAC (Ethernet) address
labeled on the rear of the camera.
Both the [Auto Set] and [Manual Set]
buttons will be activated.
2.
Click [Manual Set].
The Manual Setting dialog appears.
The default values of <IP Address>,
<Subnet Mask>, <Gateway>, and <HTTP Port> of the camera will be displayed.
The default <Password> is "4321".
3.
In the <Address> pane, provide the
necessary information.
MAC (Ethernet) Address : The MAC
(Ethernet) address of the applicable
camera will be set automatically so
you don't need to input it manually.
DDNS URL address enabling access from the external Internet.
However, this will be replaced with the <IP Address> of the camera if
DDNS registration has failed.
Scans for cameras with the IPv4 setting.
Scans for cameras with the IPv6 setting.
Scans for cameras that are currently connected to the network.
However, this button will be grayed out if neither IPv4 nor IPv6 is checked.
<IP Installer> will automatically configure the network settings for you.
You should configure the network settings manually.
Exits the IP Installer program.
Description
English _35
Advertisement
Table of Contents
