Table of Contents
Advertisement
Adjusting the monitoring direction for the camera
Tilting
You can adjust the camera direction only when the camera is fixed on the ceiling.
Then, turning the camera to the left or right is referred to as "Panning", while tilting the angle
is "Tilting". For panning, the panning limit is 220˚ for the clockwise, and 120˚ for the counter-
clockwise, a total of 340˚ enabled; further rotation is stopped by the stopper.
Adjusting the tilt
Loosen the tilt adjustment screws and rotate the lens.
Adjust the lens and the floor at the angle of 90˚, and then tighten the tilt adjustment screws
to fix the lens.
To use the <Object counting> function, adjust the camera lens vertically to face the fl oor.
Otherwise, the <Object counting> function may not work normally.
Adjusting the zoom and focus
Watch the camera's real time video and rotate the "Zoom lever" to zoom in/out the subject
as you want.
Rotate the "Focus lever" until the image looks clear.
For the position of the Zoom lever and Focus lever, refer to the "Components" (page 13).
M
It is recommended to install the camera 2.5M~10M high above from the fl oor.
Panning
Tilt Adjustment Screw
Lens rotation
English _19
Advertisement
Table of Contents
