Table of Contents
Advertisement
To set the alarm input
1.
Select <Event> - <Alarm input 1> or
<Alarm input 2>.
The Alarm Input setup window appears.
2.
When done, click [Apply].
Your settings will be saved.
Input device setup : Select an input
type according to the characteristics
of the alarm sensor on the rear of the
camera.
-
Off : Turns off the alarm input setting.
-
NO (Normal Open) : It is normally open, but if it is closed, an alarm will be triggered.
-
NC (Normal Close) : It is normally closed, but if it is open, an alarm will be triggered.
Activation time : You can set a time to execute a specifi c command when an
alarm occurs.
-
Always : Always executes the specifi ed command when an alarm occurs.
-
Only scheduled time : Executes the specifi ed command when an alarm occurs
only on a specifi ed weekday, or time.
Action : You can set an action to execute when an alarm occurs.
-
Alarm output : Set the alarm output port to which the alarm signal is transferred.
-
Output duration : Set the period of time to output the alarm signal to the
specifi ed alarm output port when an alarm occurs.
If a new alarm event is detected during the alarm output, the delay time is
recalculated based on the detection time of the recent alarm.
-
Alarm image transfer : If you select <On>, you can transfer JPEG images to a
registered address via FTP or SMTP server or save images into the SD memory card
according to the setting in <Event> - <Transfer setup>.
English _63
Advertisement
Table of Contents
