Table of Contents
Advertisement
setup screen
To set an alarm image
You can configure to send message via FTP/E-mail (SMTP) or to save recording into the
SD memory card.
Select a transfer method when an event occurs or the schedule transfer function is
activated.
1.
Select <Event> - <Alarm image>.
The Alarm Image setup window
appears.
Transfer mode : You can select
alarm message notifi cation method
among FTP/E-mail transfer and SD
Card recording.
-
FTP transfer : The image is sent to
the specifi ed FTP address.
-
E-mail transfer : The image is sent to the specifi ed email address.
-
SD Card Record : Saves images into the SD memory card.
M
J
Transferred image naming setup : You can set the fi le name of an alarm image
to be sent when an alarm is triggered or during the scheduled transfer.
Pre/post alarm image : You can set to save the pre or post alarm image.
-
Number of image : The frame rate per second can be one among 1, 2, 3, and 5.
-
Pre-alarm duration : The pre alarm duration can be one among 5 seconds, 10
seconds, 15 seconds, and 30 seconds. You can send a pre-alarm image of up
to 30 seconds before the alarm is triggered.
(The max time differs, depending on the frame rate)
-
Post-alarm duration : The post alarm duration can be one among 5 seconds, 10
seconds, 15 seconds, and 30 seconds. You can send a post-alarm image of up
to 30 seconds after the alarm is triggered.
(The max time differs, depending on the frame rate)
M
The pre/post alarm duration is not available in SMTP transfer mode.
Only one image at the corresponding time will be transferred.
2.
When done, click [Apply].
Your settings will be saved.
62_ setup screen
If an SD memory card is not inserted, the corresponding button will be disabled.
In this case, insert the SD memory card into the slot and refresh to enable the button.
If the SD memory card is ejected while the button is checked, the camera automatically
restarts.
Advertisement
Table of Contents
