Using The Magnify Feature - Christie LW401 Manual

LX501/LX601i/LW401/LW551i/LWU421/LWU501i
Operating

Using the magnify feature

1.
Press the MAGNIFY ON button on the remote
control.
The picture will be magnified, and the MAGNIFY
dialog will appear on the screen. When the
MAGNIFY ON button is pressed for the first time
after the projector is turned on, the picture will be
zoomed by 1.5 times. On the dialog, triangle marks
to show each direction will be displayed.
2.
The display magnification of the projector switches in order
with every press of the MAGNIFY ON button.
 For computer signals, HDMI
LAN, USB TYPE A or USB TYPE B ports
1.5 times  2 times  3 times  4 times  1 time
 For video signals, s-video signals, component video signals or
HDMI (Component) signals
TM
1.5 times  2 times  1 time
3.
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
buttons to shift the magnifying area.
4.
Press the MAGNIFY OFF button on the remote control to exit magnification.
NOTE
• The MAGNIFY dialog will automatically disappear in several seconds
with no operation. The dialog will appear again if the MAGNIFY ON button is
pressed when the dialog has automatically disappeared.
• The magnification is automatically disabled when the displaying signal or its
display condition is changed.
• While the magnification is active, the keystone distortion condition may vary. It
will be restored when the magnification is disabled.
• Some horizontal stripes might be visible on the image while magnification is
active.
• This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
Operating Guide
(RGB) signals, input signals from the
TM
36
MAGNIFY
ON / OFF
buttons
020-000461-02 Rev. 1 (06-2012)