Christie LW401 Manual page 84

LX501/LX601i/LW401/LW551i/LWU421/LWU501i
NETWORK menu
Item
WIRED SETUP
(continued on next page)
Operating Guide
Selecting this item displays the WIRED
SETUP menu for the wired LAN.
Use the ▲/▼ buttons to select an item,
and the ► or ENTER button on the remote
control to perform the item.
Use the ▲/▼ buttons to turn DHCP on/off.
Select OFF when the network does not have
DHCP enabled. To save the setting, press the ►
DHCP
button.
(Dynamic Host
• When the "DHCP" setting changes to "ON", it
Configuration
takes a little time to obtain IP address from DHCP
Protocol)
server.
• Auto IP function will be assigned an IP address if
the projector could not obtain an IP address from
server even if DHCP is "ON".
Use the ▲/▼/◄/► buttons to enter the IP
ADDRESS.
This function can only be used when DHCP is set
to OFF.
IP ADDRESS
• The IP ADDRESS is the number that identifies
this projector on the network. You cannot have two
devices with the same IP ADDRESS on the same
network.
• The IP ADDRESS "0.0.0.0" is prohibited.
Use the ▲/▼/◄/► buttons to enter the same
SUBNET MASK used by your computer.
SUBNET
This function can only be used when DHCP is set
MASK
to OFF.
• The SUBNET MASK "0.0.0.0" is prohibited.
Use the ▲/▼/◄/► buttons to enter the DEFAULT
GATEWAY (a node on a computer network that
DEFAULT serves as an access point to another network)
GATEWAY address.
This function can only be used when DHCP is set
to OFF.
Use the ▲/▼/◄/► buttons to input the DNS
server address.
DNS SERVER
The DNS server is a system to control domain
names and IP addresses on the Network.
Description
ON ó OFF
82
020-000461-02 Rev. 1 (06-2012)