Installation Preparation - GE GLC4000 Series Installation Instructions Manual

Installation Preparation
Installation Instructions
PREPARE ELECTRICAL WIRING
AWARNING
Zl
y
FOR PERSONAL SAFETY: Do not use an
extension cord or adaptor plug with this
appliance.
Electrical Requirements
* This appliance must be supplied with 120V, 60 Hz., and
connected to an individual properly grounded branch circuit,
protected by a 15 or 20 ampere circuit breaker or time delay
fuse.
* |f the electrical supply does not meet the above
requirements, call a licensed electrician before proceeding.
[1 Your dishwasher circuit should not be
used for any other appliance while
the dishwasher is in operation as the Sig
dishwasher requires a full capacity of ae 0
the circuit. AF
(J If the wall receptacle you plug the
dishwasher's power cord into is
controlled by a switch, turn on the
switch.
Insure proper ground
exists before use
AWARNING
Zl
@
Do not, under any circumstances, cut or
remove the third grounding prong from the
power cord.
Grounding Instructions-Power Cord Models
This appliance must be grounded. In the event of a malfunction
or breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current.
This appliance is equipped with a cord having an equipment
grounding conductor and a grounding plug. The plug must
be plugged into an appropriate outlet that is installed and
grounded in accordance with all local codes and ordinarices.
CARN IMG) The improper connection of the equipment
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or service representative if you
Se are in doubt that the appliance is properly
grounded. Do not modify the plug provided
with the appliance, if it will not fit the outlet,
have a proper outlet installed by a qualified
technician.
STEP 1 REMOVE WOOD BASE
| M PORTANT - Do not kick off wood base! Damage
will occur.
* Move the dishwasher close to the installation location and lay
it on its back.
e Remove the four skid bolts on the underside of the wood
base with 3/8" nut driver.
e Discard base and bolts.
* Upright the dishwasher.
STEP 2 INSTALL FAUCET ADAPTER
The special faucet adapter supplied with your dishwasher
must be attached to the sink faucet before you can use your
dishwasher.
The faucet adapter is designed to fit standard spouts having
internal or external threads. You will find the adapter and two
washers in the faucet adapter packet in your dishwasher.
* To install faucet adapter, first remove the old aerator or trim
ring on your faucet spout.
External Threads
« lf faucet has external threads: Insert the
thinner of the two washers into the faucet
adapter and attach it to the faucet spout.
* Tighten with pliers.
Internal Threads
* |f faucet has internal threads: Insert both
of the washers into the faucet adapter
and attach it to the faucet spout.
* Tighten with pliers.
Non-Standard Threads
* |f the faucet adapter threads do not
match your faucet spout, your local
hardware or plumbing supply store
normally has additional fittings to adapt
your faucet spout to the special faucet
adapter.
CAUTION: A sink spray attachment hose can burst if it is
installed on the sarne faucet as your dishwasher. We suggest
that you disconnect the sink spray attachment, if your sink has
one, and place a cap over the opening.