Table of Contents
Advertisement
Once the message
and Gateway address. If these are missing, you should carry out a manual configuration (see
below).
Manual configuration
To configure your terminal manually, you should obtain the usual information used to set a peripheral
device (IP address, sub-network mask, network and gateway address).
To configure the local network setting manually:
Choose
IP address
Enter the IP address of your terminal and press OK to confirm.
Sub-network mask
Enter the sub-network mask of your terminal and press OK to confirm.
Gateway address
Enter the IP address of the network gateway and press OK to confirm.
IEEE address (or Ethernet address) or MAC address
The Ethernet card of your terminal already has an unmodifiable, yet consultable, IEEE address.
Netbios names
These names, which can be used with the network options, are used to identify your terminal machine
from a PC connected to a local network (for instance with the name "IMP-NETWORK-1".
Enter the selected name (15 characters max) and press OK to confirm.
has disappeared, check for the IP Address, Sub-network mask
SELF-CONF
2531 OK - SETUP / NETWORKS / LOCAL NETWORK / CONFIGURATION
and press OK to confirm.
MANUAL
2532 OK - SETUP / NETWORKS / LOCAL NETWORK / IP ADRESSE
2533 OK - SETUP / NETWORKS / LOCAL NETWORK / SUBNET MASK.
2534 OK - SETUP / NETWORKS / LOCAL NETWORK / GATEWAY
2535 OK - SETUP / NETWORKS / LOCAL NETWORK / IEEE ADRESSE
2536 OK - SETUP / NETWORKS / LOCAL NETWORK / NETBIOS 1
2537 OK - SETUP / NETWORKS / LOCAL NETWORK / NETBIOS 2
4-12
Setting your machine
Advertisement
Table of Contents
