Ipod® Playback - Denon AVR-1908 Owner's Manual

ENGLISH
f"G)
I
~
I :;'
I <0
I
~
.
.,
i
~
L.::..
I (")
I
g
I ;;
j
~
!
o'
I
~
I
5
I "
I
~
i
~
£.
r - -
I
S
I
t
IT
i
g'
r-;-
I ~
.
"
I
U>
I g-
I
~
I ~.
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio files and achieve a richer sound.
The default setting is "Mode3':
• Press <ON/STANDBY> and set the AVR-1908's power to the standby
mode before disconnecting the iPod. Also switch the input source
to one to which the menu "iPod dock" is not assigned before
disconnecting the iPod.
-NeI'.
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
iPod® Playback
The musIc on an IPod can be played by USing the Control Dock for
IPod IASD-l R, sCld separately)
The operation can also be performed uSing the buttons on the main
unit or remote control unit while watching the menus
MENU:
"Input Setup" - "Assign" -
"iPod dock"
(~page 33)
Basic ·Operiltior(
(iPod screen)
*
If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
1
Make the necessary preparations.
CDSet the iPod in the DENON Control Dock for iPod.
(~See
the Control Dock for iPod's operating instructions.)
®Assign the Control Dock for iPod's input.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
*
The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
2
Either tum
<SOURCE SELECT>
or press
[iPod]
to
select the input source assigned in step
l-CV
above.
3
Set
[MODE SELECTOR 1]
to "AUDIO" and
[MODE
SELECTOR 2]
to ''iPod/NETWORK''.
(~page 48 "Remote Control Unit Operations")
GOOD Signal strength is good
MARGINAL
Signal strength is marginal
WEAK
Signal strength is weak
NO
No signal
L-,:CJ::
H !j'
T~:~JF.~.:' ~ : " : = " : ' k ~4===:j1-
Channel category
1
Either
turn
<SOURCE SELECT>
or press
[SAT TU]
to
select
''XM''.
2
Press
STATUS
until ''SIGNAL'' appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
The strength of both the XM satellite and terrestrial signals can be
checked at menu "Input Setup" - "Antenna Aiming" (!l2U'page 34).
4
Press
STATUS
until the station you want to check
(example:
''XMOOl'')
is displayed.
3
Adjust the position of the antenna until "SIGNAL:
GOOD" is shown on the display.
5
Press
TUNING
and select channel 0 (XMOOO).
The radio ID is shown on the display.
1>,;['1000 PADIO ID dRadiolD
2 Use
<J t>
to select the category, then use
D. V
to select
the desired station.
44