Listening To Preset Stations; Ipod ® Playback; Preparations - Denon AVR-589 Owner's Manual

Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT> <PRESET CHANNEL>
<ON/STANDBY> <STATUS> SHIFT
[Front]
[POWER OFF]
[iPod]
[2]
[1]
SHIFT
[6], [7]
[8], [9],
[CHANNEL + –]
[uip]
[ENTER]
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]


Listening to Preset Stations

1
SHIFT
Press to select the memory block (A to G).
BUTTON
<BUTTON>
2
<PRESET CHANNEL>
[BUTTON] Press
select the desired preset channel (1 to 8).
n Default settings
Auto tuner presets
87 .5 / 89.1 / 98.1 / 108.0 / 90.1 / 90.1 / 90.1 /
A1 ~ A8
90.1 MHz
522 / 603 / 999 / 1404 / 1611 kHz,
B1 ~ B8
90.1 / 90.1 / 90.1 MHz
C1 ~ C8
90.1 MHz
D1 ~ D8
90.1 MHz
E1 ~ E8 90.1 MHz
F1 ~ F8 90.1 MHz
G1 ~ G8 90.1 MHz
[Rear]
iPod ® Playback
The music on an iPod can be played by using the control dock for
iPod (ASD-1R, ASD-3N or ASD-3W, sold separately).
The operation can also be performed using the buttons on the
remote control unit.
[iPod]
iPod is a trademark of Apple Inc., registered in the U.S.
[TUNING + –]
and other countries.
[MODE]
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
[uip]
permitted for your private use as an individual. Be sure to comply
[ENTER] with applicable copyright legislation.

Preparations

1
Make the necessary preparations.
q S et the iPod in the DENON control dock for iPod.
(vSee the control dock for iPod's operating instructions.)
w Assign the control dock for iPod's input.
The input for the control dock for iPod is assigned to VCR by
default.
"System Setup" – "Input Setup" – "iPod Assign"
(vpage 21)
2
Either turn
select the input source assigned in step 1-w above.
3
[SOURCE CONTROL 1]
Set
CONTROL 2]
[CHANNEL + –]
or to
(vpage 36 "Remote Control Unit Operations")
4
[MODE]
Press
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, "Remote" is displayed.
[Selectable mode]
Display location
Playable
files
Active
buttons
z 1 : When using an ASD-3N or ASD-3W control dock for iPod
z 2 : Video may not be output, depending on the combination of
ASD-1R and iPod.
• With the default settings, the iPod can be used connected to the
VCR (iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" (vpage 28).
<ON/STANDBY>
• Press
to the standby mode before disconnecting the iPod. Also switch the
input source to one to which "iPod Assign" is not assigned before
disconnecting the iPod.
• When using an ASD-3N or ASD-3W control dock for iPod, refer to
the respective manual to operate.
<SOURCE SELECT> [iPod]
or press
[SOURCE
to "AUDIO" and
to "iPod/NETWORK".
and hold it down for a 2 seconds or
Browse mode Remote mode
Main unit display iPod display
Audio file
S S
Video file S z 1 S z
Remote
control unit S S
(AVR-589)
iPod A S
[POWER OFF]
or and set the AVR-589's power
to
2
.