Searching Categories; Ipod ® Playback; Basic Operation - Denon AVR-688 Owner's Manual

ENGLISH
<SOURCE SELECT>
<ON/STANDBY>
[Front]
[1]
[6], [7]
[8], [9]
uiop
[MODE
SELECTOR 1]
[Rear]
[MODE]
uiop
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit


Searching Categories

STATUS
ui
1
Press o p
C A T :
2
o p
Use to select the category, then use
the desired station.
op
• "LOADING" is displayed while stations or data are being received.
• "UPDATING" is displayed while the encording code is being
updated.
• "XM – – –" is displayed if the selected channel cannot be used.
[CHANNEL +/–]
iPod ® Playback
[2]
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, sold separately).
The operation can also be performed using the buttons on the
remote control unit.
iPod is a trademark of Apple Inc., registered in the U.S.
[ENTER]
and other countries.
b The iPod may only be used to copy or play contents that are not
STATUS
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
[MODE
with applicable copyright legislation.
SELECTOR 2]
[iPod]
[ENTER]
.
Channel category
R o c k
ui
to select

Basic Operation

1
Make the necessary preparations.
q S et the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod's operating instructions.)
w Assign the Control Dock for iPod's input.
"System Setup" – "Input Setup" – "iPod Assign"
(vpage 26)
2
<SOURCE SELECT>
Either turn
select the input source assigned in step 1-w above.
R e m o t e i P o d
b
If the displays above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
[MODE SELECTOR 1]
Set to "AUDIO" and
SELECTOR 2]
to "iPod/NETWORK".
(vpage 43 "Remote Control Unit Operations")
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" (vpage 33).
• Press <ON/STANDBY> and set the AVR-688's power to the standby
mode before disconnecting the iPod. Also switch the input source to
one to which "iPod Assign" is not assigned before disconnecting the
iPod.
[iPod]
or press to
[MODE