Denon AVR-1908 Owner's Manual page 26

ENGLISH
Room EO
Select room EO setting method.
[Selectable items]
~
:Apply settings to all surround modes.
Assign :
Make settings for each surround mode separately.
Direct Mode Setup
.~:':.~:~
_
,.~~.'~r:\~.~: ",~. ~
.
5e1e¢t
.SeftifigS
fdr
room
E9..
miC.
~tc
..
Select room EO use for DIRECT or PURE DIRECT mode.
II
Parameter Check
Check auto setup measurement results.
This is displayed after the auto setup procedure is completed.
[Selectable items]
Speaker Config. Check Distance Check
Channel Level Check
CrussoverFfeq.Check
EQCheck
[Selectable items]
ON
Use room EO.
~:
Do not use room EO.
~
The auto setup results can be set again when "Restore" is selected.
the • Check the polarities of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected. If
you are sure that the wiring is correct. select "Skip':
• Displayed speaker could not be detected. • Check the connections of the displayed speaker.
· The front R speaker were not properly
detected.
Only one channel of the surround speakers
was detected .
· Sound was output from the R channel
when only one surround back speaker was
connected.
· The surround back, but the surround speaker
was not detected.
• Displayed speaker connected with
polarities reversed.
IJ~Front
...,.1. •
4
Ret r y
~
Cancel~
Ski ~
Ret r y
~
Cancel~
IJ~Front
Ret r y
~
Cancel ~
• Too much noise in the room for accurate. Either turn off any device generating noise or move it
measurements to be made. away.
• Try again when the surroundings are quieter.
• Speaker or subwoofer sound is too low for • Check the speaker installation and the direction in
accurate measurements to be made. which the speakers are facing .
• Adjust the subwoofer's volume.
Auto Setup
Audwe\
Mu It EQ
=~~ t4l!i~' I,M
~
§
&
• Included setup microphone is not connected. • Connect the included setup microphone to the SETUP
MIC
jack on the main unit.
• Not all speakers could be detected. • Check the speaker connections .
Auto Setup
AudWe&
Mu It EQ
=~= l4~"~' I,N
~
§
&
•
'~i
Select "Retry" to measure again.
'N,O_
Be sure to turn the power off before checking the speaker connections.
23