Denon AVR-1908 Owner's Manual page 25

)
)
----
)IJ
When "Calculate" is selected at "STEP2'; the measurements taken
I~'
are analyzed automatically to determine how the speaker system
interacts with the room.
Once the auto setup procedure is complete, a measuring result
checking screen appears.
Select any item whose results you want to check to review the
results.
The auto setup measurement results are stored in the AVR-1908.
( Step 4 : Check
Values that are different from the actual distance may be set for
speakers with built-in filters (subwoofers, etc.). This is because filters
add electrical delay to the signal that should be compensated.
-U.na
Do not turn the power off while the settings are being stored.
•
T he time required for this analysis depends on the number of speakers
connected. The higher the number of speakers, the longer the time
required for analysis.
( Step 5 : Store
)
( Step 1 : Speaker Detection
The speaker connection and polarity are detected at the first
measurement position. The following attributes are also determined
at this time: "Speaker Size'; "Speaker Distance'; "Channel Level';
"Crossover Frequency':
Once the measurements are completed, the results are displayed.
-d·na
• Loud test sounds may be played during Audyssey MultEO Automatic
Speaker Setup. This is part of normal operation. If there is background
noise in room, these test signals will increase in volume.
• Do not stand between the speakers and setup microphone or allow
obstacles in the path while the measurements are being made. This
will cause inaccurate readings.
• Ouiet the listening environment before beginning measurements and
refrain from talking. Turn off air conditioning units or other devices
that emit noise if at all possible as measurements may be affected
by these sounds.
• Operating the MASTER VOLUME knob on the main unit or remote
control during measurements will cancel the measurements.
• Do not change the speaker connections or subwoofer volume after
"Step 1':
After completing a measurement position, move the microphone to
the next position.
Measure 6 positions (main listening position and 5 other surrounding
positions). Although it is allowable to measure less than 6 positions, it
is recommended to measure 6 for best results.
( Step 2 : Measurement
Start
Start Auto Setup.
The Audyssey MultEO ALita Setup process automatically calculates
the size, level. distance,
ba$;S
management crossover frequency, and
optimal settings for each sll:€aker and subwoofer. Audyssey MultEO
corrects acoustical distortliiOlns within the listening area.
Before starting, connect
a~dI
position all your speakers.
Once started, MultEQ WII playa series of test tones through each
speaker.
If an error message app8'.af:S; during the measurements, check "Error
Messages'; take the ad"l'i.E!d action, then start the measurements
again ((W'page 23).
Front Speaker
The front speaker to be- Inleasured can be selected ahead of time
here.
[Selectable items]
OJ:
Output test ton e
f~,[)m
front speakers A.
B : Output test ton e
f~ll)m
front speakers B.
A
+ B :
Output test tone In,om front speakers A and B.
Amp Assign
Advanced setting :
changt€~
power amplifier assignment.
For details, refer to ':Amp k;sign" ((W'page 28).
22