Leslie Control Center - Leslie 2101 Owner's Manual

controls that enhance the organ sounds
P OW ER
O N
10
O FF
R EMO TE
(
L ES L IE
11P IN
1
5
REMOTE
to Lesli e 2121
6
The Leslie Control Center is located on the back panel of the Leslie Speaker.
1 - 11-pin Receptacle -
the cable supplied with the speaker.
2 - 8-pin DIN Receptacle -
instruments using the special cable provided for this connection.
3 - ROTARY LINE IN -
4 - LINE OUT:
STATIONARY & BASS (L/MONO, R) Jacks -
ROTARY channels to be connected to an external amplifier. To connect the STATIONARY UNIT #2121, connect the
L/MONO OUT to INPUT 2.
ROTARY (L/MONO, R) -
connect the STATIONARY UNIT #2121, connect the L/MONO OUT to INPUT 3.
NOTE: The HORN ROTOR channel has no LINE OUT connection due to the acoustic nature of the sound produced. Using
the HORN ROTORY channel with external amplification requires a microphone.
5 - AC Power Cord Receptacle -
an AC outlet.
6 - REMOTE -
When the Leslie 2121 Stationary-Unit is connected, connect to the REMOTE IN with a DCC-2 cable. The power
for the Stationary-Unit can be turned "ON" and "OFF" by the power switch of the Horn-Unit.
NOTE: The REMOTE feature is powered by a battery. The battery's estimated life is approximately 1000 "turn-ons,"
depending on constancy of electircal current, etc. Do not attempt to replace this battery . Refer all servicing to qualified
service personnel.
7 - FOOT SW -
PRESET -
SLOW/FAST/STOP -
Switch is activated, the rotors will switch between SLOW and FAST. If the Foot Switch is pressed and held for 1
second, the Rotors will Stop.
8 - MIDI IN - Connects to the MIDI OUT of an organ or keyboard.
9 - MIDI OUT - Connects to the MIDI IN of an additional Leslie Horn-Unit when 2 units are connected in series. The MIDI IN
from the organ and the FOOT SW signal of the Horn-Unit are merged in the MIDI OUT.
10 - Power Switch ON / OFF -
21
R ot ar y-Unit
)
STAT IONARY
L R
ROT
BASS
LEV
O 10 O 10
VOLUME
STAT IONARY
& ROT. BAS S
L/MONO
L/MONO R
L IN E O UT
4
This allows direct connection between the Leslie Speaker and the Hammond XB-Series Organs, using
This allows direct connection between the Leslie Speaker and the Hammond XB-1 and XM-1
This allows other instruments to connect to the Rotary channel using standard phone cables.
This allows the LOW ROTARY channel to be connected to an external amplifier. To
Plug the female end of a grounded AC power cord into this receptacle, and the male end into
Allows you to switch between PRESET 1 and 2 using a latching-type Foot Switch.
Allows you to control the Leslie rotors using the FS-9H Foot Switch. Each time the Foot
This allows the Leslie Speaker to be turned "ON" or "OFF."
FU NCTIO N
Slow Speed [Control Ch]
[Prog. Ch]
Fast Speed
Rise Time [Mod Rx]
HORN
L EV E L
Fall Time
[S/F Type]
Brake Time
Rotor Direction /Mic Angle
Horn Character /Mic Distance
Cross Over Freq./ Cabi. Resonance
ROTARY OVER DRIVE
MEMORY
O 10 O 10
NORMAL
STA
MONO
ROTARY ROTARY
R
L ES L IE
L IN E IN
8P IN
2
3
These allow both the STATIONARY and the LOW
V AL U E
DOW N
21
[Exp Rx]
[S/F Cont.Code]
[Dump Out]
[P.F.SW Type]
[ MIDI ]
Touch & Hold
HORN LOW
ROTOR
ROTOR
FUNCTION
SELECT
P RES ET
1
2
PRESET
SELECT
BASS
& STA
MUTE
SLOW / FAST
PRESET
STOP
FO OT SW MID I IN
7
9
UP
9
MID I O UT
8
Continued on next page.