Table of Contents
Advertisement
4
Ë Connecting to the XE-1/CMS-100/XT-series/XH-series using the 11-pin
receptacle
P OW ER
G EN ERAL
OFF
ON
The above example show a Hammond XE-1 connected to a Leslie Horn Unit. The audio signal is
connected via an 11-pin Leslie Cable. The above hookup can be used with any current Hammond
Organ; however, all MIDI features may not be able to be controlled. Please see page 27 for more
information.
To make this hookup:
1.
2.
3.
4.
5.
6.
NOTE: In addition, a MIDI cable can be connected from the MIDI OUT of the organ to the MIDI IN of the
Leslie to allow the organ to control the Advanced Features of the Leslie.
Make sure the power to both units is "OFF."
Set the STATIONARY Volume Controls on the Leslie Speaker to a low setting (the 10
o'clock position is recommended) when first making the connection.
Set the ROTARY Volume Control to a low setting (the 10 o'clock position is
recommended) when first making the connection.
Plug the female end of the Leslie Connector Cable into the receptacle on the back of the
Leslie Speaker.
Plug the male end of the Connector Cable into the 11-pin Leslie socket of the organ.
Turn the organ "ON." After about 5 seconds, the Leslie Speaker will turn "ON." Then
adjust the volume settings of both units to your liking.
STATIONARY
ROTARY
L
R
R OT
BA SS
LEV
O
10
O
10
O
10
VO LU ME
Hide quick links:
Advertisement
Table of Contents
