Connecting The Leslie 2121 Stationary-Unit; Rot Bass Level / Horn Level - Leslie 2101 Owner's Manual

6
Ë Connecting the Leslie 2121 Stationary-Unit
To connect the Leslie 2121 Stationary-Unit to the Horn-Unit, do the following:
1.
2.
3.
4.

ROT BASS LEVEL / HORN LEVEL

These two Trim Pots can be adjusted using a small screwdriver.
= Minimum setting.
It is recommended that you set these Trim Pots as shown when first making the connections, then
adjust them later to your preference.
Make sure the power to all units, including the connecting instrument, is "OFF."
Connect the Stationary Unit as shown below. Set the controls on the Stationary-Unit
similar to the settings shown below. Set the ROT BASS LEVEL and HORN LEVEL
trimpots on the Horn-Unit as shown.
2101 Standard Setting
NOTE: the two LI-40 audio cables and the DCC-2 power connecting cable are supplied with the
2121 Stationary-Unit.
Turn on the connecting instrument. Both Leslie units will be powered up
automatically.
Finally, turn the MASTER VOLUME Rotary Control of the 2121 to the center (12
o'clock) position to check the sound level, then adjust the sound to your liking.
= Maximum setting.
ROT
BASS HORN
LEVEL LEVEL
POWER
2101 Setting for use with
the 2121 Stationary-Unit
ROT
BASS HORN
LEVEL LEVEL
= Center position.