Making The Connections; Connecting To A Single-Channel Hammond Organ Using The 11-Pin Receptacle - Leslie 2101 Owner's Manual

making the
connections
Ë Connecting to a single-channel Hammond Organ using the 11-pin receptacle
The above example show a Hammond XK-2 connected to a Leslie Horn Unit. The audio signal is
connected via an 11-pin Leslie Cable.
To make this hookup:
1.
2.
3.
4.
5.
6.
NOTE: In addition, a MIDI cable can be connected from the MIDI OUT of the XK-2 to the MIDI IN of the Leslie
to allow the XK-2 to control the Advanced Features of the Leslie. Please see page 28 for more information.
NOTE: The above hookup will also work with older Hammond products such as XB-2, XB-5 and XB-3;
however, all MIDI features may not be available. Please see page 27 for more information.
Make sure the power to both units is "OFF."
Set the STATIONARY Volume Controls on the Leslie Speaker to "0" or Off to reduce
noise, since the XK-2 uses the Rotary channel only.
Set the ROTARY Volume Control to a low setting
(the 10 o'clock position is recommended) when first making the connection.
Plug the female end of the Leslie Connector Cable into the receptacle on the back of the
Leslie Speaker.
Plug the male end of the Connector Cable into the 11-pin Leslie socket of the organ.
Turn the organ "ON." After about 5 seconds, the Leslie Speaker will turn "ON." Then
adjust the volume settings of both units to your liking.
ST AT ION AR Y
ROTARY
L R
ROT
B A S S
L E V
O O 10 O 10
10
VOLUM E
3