Table of Contents
Advertisement
Hardware Reset
There is a reset button on the inner side of the Network
Camera.
It is used to
reboot the Network Camera or restore the Network Camera to factory
default.
Sometimes rebooting the Network Camera could set the Network Camera
back to normal
state.
If the problems remain after rebooted, restore the
Network Camera to factory default and install again.
Reboot: Press and release the reset button with a
needle.
Wait for the
Network Camera to reboot.
Restore: Press the indented reset button continuously for over 30 seconds
until the status LED rapidly blinks red and green
simultaneously.
Note that all
settings will be restored to factory default.
Advertisement
Table of Contents
