Table of Contents
Advertisement
Mute: Select this option to disable audio transmission from the Network Camera to all
Note that if mute mode is turned on, no audio data will be transmitted to all clients even though
the audio transmission is enabled in the Client Settings page. In that case, the following
message is displayed.
Input gain: There are two options for external microphone input gain, 0db and 20db.
Audio type: Select audio codec AAC or GSM-AMR and the bit rate.
■ AAC targets at performing good sound quality at the cost of higher bandwidth consumption.
The bit rates are selectable at the following rates: 16Kbps, 32Kbps, 48Kbps, 64Kbps, 96Kbps
and128Kbps.
■ GSM-ARM is designed to optimize speech quality and requires less bandwidth. The bit rates
are selectable at the following rates: 4.75Kbps, 5.15Kbps, 5.90Kbps, 6.7Kbps, 7.4Kbps,
7.95Kbps, 10.2Kbps and 12.2Kbps.
When completed with the settings on this page, click Save to take effect.
Motion detection
This section explains how to configure the Network Camera to enable motion detection. A total
of three motion detection windows can be configured.
Note: Motion detection will be disabled while camera is doing PTZ.
To enable motion detection, follow the steps below:
1. Click New to add a new motion detection window.
2. In the Window Name text box, enter a descriptive name for the motion detection window.
■ To move and resize the window, drag-drop the window.
■ To delete window, click X at top right of the window.
3. Define the sensitivity to moving objects and the space ratio of all alerted pixels by moving
the Sensitivity and Percentage slider bar.
clients.
Advertisement
Table of Contents
