Table of Contents
Advertisement
Installation
Hardware installation
Follow the steps below to install the Network Camera to the ceiling:
1. Attach the alignment sticker to the wall.
2. Drill four pilot holes into the wall.
3. Attach the black cover to the Network Camera using the supplied four
black screws.
4. Stick the supplied two pieces of silica gel symmetrically to the inner side
of the dome cover. Then place the metal ring into the dome cover to fix the
silica gel.
5. Fix the dome cover to the Network Camera and secure it by rotating it
clockwise.
6. Loosen the three screws on the front opening of the wall mount bracket.
7. Place the O-ring on the front opening of the wall mount bracket.
8. Feed the cables through the front opening of the wall mount bracket and
pull them from wall outlet.
9. Attach the Network Camera to the wall mount bracket by tightening the
three screws on the front opening of the wall mount bracket.
10. Fasten the wall mount bracket to the wall.
Advertisement
Table of Contents
