Pioneer DEH-P9400MP Operation Manual page 62

When problems occur during CD play, an error message may appear on the display. If an error mes-
sage appears on the display, refer to the table below to see what the problem is and the suggested
method of correcting the problem. If the error cannot be corrected, contact your dealer or your near-
est Pioneer service center.
ERROR- l-i, 12; 17,30
Dirty disc. Clean disc.
ERROR- 11.12. 17,30 Scratched disc.
Replace disc.
ERROR- 22,23
The CD format cannot be Replace disc.
played back.
ERROR- tO,-ll, 12, 17,
Electrical or mechanical Turn the ignition ON and OFF, or
30, 50, A0 problem.
switch to a different source, then
back to the CD player.
ERROR- 44
All tracks are skip tracks. Replace disc.
HEAT
No audio
CD player overheated.
Nothing has been recorded
or the CD format cannot be
played back.
Turn off the CD player and wait
until the CD player cools down.
Replace disc.
-
When correct measurement of car interior acoustic characteristics is not possible using the auto--
equalizer, an error message may appear on the display. If an error message appears on the display,
refer to the table below to see what the problem is and the suggested method of correcting the prob-
ERROR CHECK MC
Microphone is not connected. Plug the supplied microphone
securely into the jack.
ERROR CHECK SPEAKER The microphone cannot pick
Confirm that the speakers are
up the measuring tone of the connected correctly.
front and rear speakers. Correct the input level setting of the -
power amp connected to the
sneakers.
Set the microphone correctly.
ERROR Ci-lECK SYSTEM The surrounding noise level
Stop your car in a place that is as
is too high.
quite as possible, and switch off the
engine, air conditioner or heater.
Set the microphone correctly.
Auto EQ unavailable The operation mode set
The auto-equalizing function does
to NW mode.
not wark in NW mode.