Pioneer DEH-P9400MP Operation Manual page 53

The initial settings menu has the following func-
tions:
Ii
nu
You can operate the initial settings menu only
when the source is off.
1.
2.
- When the source is off, you can check the
location of " - '1" by turning on the feature
demo.
c Press BAND to cancel the initial settings men&
If you do not carry out an operation within about
30 seconds, screen indications will start to
reverse, and then continue reversing every 10
seconds.
You can turn the reverse rnode on or off.
0 Press REV again to turn the reverse mode
Off.
The feature demo automatically starts when
power to this product is switched off while the
ignition switch is set to ACC or OM.
You can turn the feature demo on or off.
"CM" appears in the display.
0 Press F.DEMO again to turn the feature
derno off.
* The red lead (KC) of this product should be con-
nected to a tenninal coupled with ignition switch
ON/OFF operations. If this is not done, the vehicle
battery may be drained.
It is possible to use auxiliary equipment with
this product.
Turn the auxiliary setting on when using auxil-
iary equipment connected to this product.
"ON" appears in the display.
0 Press AUX again to turn AUX off.