Special Id Programming (Cv 56.129) - Lionel HO Veranda Owner's Manual

Programming your locomotive in the DCC
environment

Special ID programming (CV 56.129)

If you cannot program your ID number in Service Mode and your command station prevents
you from changing your ID in Ops Mode using CV 1, CV 17 and CV 18, use the following
alternative procedure to program your locomotive ID numbers.
Entering short (primary) address in CV 56.129 in Ops mode
1. Set CV 49 to 129.
2. Set CV 50 to 1.
3. Set CV 56 to your short address. Hear the address spoken back.
4. Change CV 29, bit 5 to "0" (or set CV 29 to 2 which is factory default) to
enable your new primary address.
Entering your long (extended) address in CV 56.129 in Ops mode
1. Determine the value of CV 17 and CV 18 for your locomotive's extended
address from Table 6 below.
2. Set CV 49 to 129.
3. Set CV 50 to 17.
4. Enter CV 17 into CV 56. There will be no verbal response.
5. Set CV 50 to 18.
6. Enter CV 18 into CV 56. Hear the new full address spoken out.
7. Change CV 29, bit 5 to "1" (or set CV 29 to 34) to allow operation with
your new extended address.
Loco Number
61
73
Table 6. CV 17 and CV 18 values
CV 17 CV18
(Dec) (Dec)
192 61
192 73
CV17 CV18
(Hex) (Hex)
CO 3D
CO 49
23
CV 17 CV18
(Binary) (Binary)
11000000 00111101
11000000 01001001