Changing Individual Sound Volumes (Cv 52.X); Reset Cv's To Factory Default Values (Cv 56.128.255) - Lionel HO Veranda Owner's Manual

Programming your locomotive in the DCC
environment

Changing individual sound volumes (CV 52.X)

To change the volume of individual sounds listed in the table below:
• Set CV 49 to the Primary Index for the individual sound from the Table 5 below.
• Enter Volume level in CV 52 as follows: 0 for No Sound; 1 – 15 to set the volume from the
lowest value at "1", the highest volume at "15". The volume levels are in 2db increments.
Primary Index set by CV 49
0
8
10
13
15
16
19
21
22
24
28
34
37
Table 5. CV 49 default settings

Reset CV's to factory default values (CV 56.128.255)

This does not affect analog settings, except volumes.
Note!
1. Write 128 to CV 49.
2. Write 255 to CV 50.
3. Write 113 to CV 56. In Ops mode, you will hear three horn blasts when reset is completed.
Sound
Horn
Bell
Diesel motor
Turbine whoosh
Turbine whine
Air pump
Diesel motor cooling fans
Long air let-off
Short air let-off
Squealing brakes
Dynamic brakes
Coupler sounds
Air brake volume
22
Default
11
11
9
12
8
10
8
11
11
11
8
11
11