Table of Contents
Advertisement
LEGACY and Command Control Remote Operations
LEGACY Control operations
Y
our VISION Horse/Reindeer Car is designed for operation with the Lionel LEGACY system. It will
also operate on the original Lionel Trainmaster System (TMCC1) with limited features and also
on the LEGACY Cab-1L / Base-1L operating system (again with reduced features.) Using a Lionel
Your commands are sent by the Remote Controller to the Command Base, which broadcasts a
radio frequency that is distributed through the outside rails of the track to your sound equipped
car
1. Turn o track power, and then plug in the LEGACY Base and connect it to the
track.
2. Place your horse/reindeer car on the track.
3. Increase track power (no more than 18 volts AC) . If a circuit breaker trips when you
turn on the Lionel power supply, check the wheels of your car to make sure they are all
securely on the track. Check to make sure the track is free of all metals that may cause a short
circuit.
4. Moving your Vision
turns on the sound.
Choosing an ID for your VISION Horse/Reindeer Car
T
he VISION Horse/Reindeer Car must be given a unique Engine ID. Use the Program / Run switch
and follow the instructions on Page 4. Setting it to the same LEGACY or TMCC ID as the locomotive
pulling it will result in undesired operation. Once a unique ID is set, the VISION Horse/Reindeer Car
should be assigned to a train along with your locomotive.
If you have more than one VISION Horse/Reindeer Car, for best results set them all to unique ID's.
You may also choose to set them all to the same ID. In this case, set one horse/reindeer car's min/max
switch to the MAX position (see page 5) and all others to MIN.
powering up the track automatically
6
r.
Advertisement
Table of Contents
