Table of Contents
Advertisement
DCC operations
Lionel Specific CV Settings
Lionel's Manufacturer ID is 73 (The Electric Railroad Co.)
1.
CV 1, Short Address
2.
CV 3, Acceleration Rate
3.
CV 4, Deceleration Rate
4.
CV 7, Code Version
5.
CV 8, Manufacturer ID (73) [write to 08 => full decoder reset]
6.
CV 17 & 18, Long Address
7.
CV 19, Consist Address
8.
CV 29, Operating Modes, see DCC spec.
9.
CV 47, Analog Horn Channel (Quilling)
10. CV 50, Consist Position (1 = Lead, 2 = Mid, 3= End)
11. CV 54, Brake Squeal Sound (set zero (0) to disable or one (1) to enable)
12. CV 58, Control and Consist Filter Setting* (default = 3)
13. CV 59, Speed Step 128 Filter Setting* (default = 5)
14. CV 60, Speed Step 28 &14 Filter Setting* (default = 5)
15. CV 61, Function Groups Filter Setting* (default = 3)
16. CV 62, Config Variables Filter Setting* (default = 3)
17. CV 67 to 94, Speed Table 28 (active for 14 and 28 step mode only)
* Filter valid settings are 1 to 8. The filter settings are used to help prevent dirty track from
affecting loco operation by rejecting commands that do not repeat for the selected count
within a short period of time. For example, if the loco is on speed step 20 and the user sets
speed step 30, the default filter setting of 5 requires five speed step 30 commands to change to
speed step 30. Normally commands are repeated often enough in DCC controllers to pass the
default filter settings selected.
If your locomotive stops occasionally, increase the filter setting for CV59 and
CV60. If the loco does not respond to all speed commands, decrease the filter
setting for CV59 and CV60.
26
Advertisement
Table of Contents
