Table of Contents
Advertisement
LEGACY and Command Control Remote
Operations
LEGACY Control operations
Y
our VISION Auxiliary Water Tender is designed for operation with the Lionel LEGACY system. It
will also operate on the original Lionel Trainmaster System (TMCC1) with limited features and
also on the LEGACY Cab-1L / Base-1L operating system (again with reduced features.) Using a Lionel
LEGACY set (6-14295) will allow you to access ALL the features this tender has to offer.
Your commands are sent by the Remote Controller to the Command Base, which broadcasts
a radio frequency that is distributed through the outside rails of the track to your sound equipped
tender. Moving your train after you power up your track will turn the sounds on.
1. Turn off track power, and then plug in the LEGACY Base and connect it to the
track.
2. Place your Auxiliary Water Tender on the track.
3. Increase track power (no more than 18 volts AC). If a circuit breaker trips when
you turn on the Lionel power supply, check the wheels of your tender to make sure they are all
securely on the track. Check to make sure the track is free of all metals that may cause a short
circuit.
4. Moving your Vision Auxiliary Water Tender after powering up the track
automatically turns on the sound.
Choosing an ID for your VISION Auxiliary Water Tender
T
he VISION Auxiliary Water Tender must be given a unique Engine ID. Use the Program / Run
switch and follow the instructions on Page 4. Setting it to the same LEGACY or TMCC ID as the
locomotive pulling it will result in undesired operation. Once a unique ID is set, the VISION Auxiliary
Water Tender should be assigned to a train along with your locomotive.
If you have more than one VISION Auxiliary Water Tender, for best results set them all to unique
ID's. You may also choose to set them all to the same ID. In this case, set one tender's min/max
switch to the MAX position (see page 5) and all others to MIN.
6
Advertisement
Table of Contents
