Assigning Your Interurban Car A New Id - Lionel Interurban (M.U.) Car Owner's Manual

TrainMaster Command operations

Assigning your Interurban Car a new ID#

Assign a new ID# to your
Example
Command-equipped
Interurban Car
Set the Interurban Car Command reverse
unit switch to PGM
Command Base plugged in
Place the Interurban Car on track
PowerMasters set to CMD or traditional
power supplies ON FULL (no more than 20
volts)
Turn track power on (PowerMasters):
Press BOOST
Program the Interurban Car with a new
ID#:
Press ENG
Press a number you choose
(the ID#)
Press SET
Set the reverse unit switch to RUN
Your Interurban Car remembers its ID#
forever; change it any time with
these steps.
A s your fleet of Command-equipped
Lionel locomotives grows, you'll want
to give your Interurban Car a more individ-
ualized number. Choose from any between
1 and 99. To make things easy, use a
portion of your Interurban Car's cab
number.
Set the Interurban Car's Command
reverse unit switch to PGM (see the illustra-
tion on page 5). Plug in the Command
Base and place the Interurban Car on track,
then power up. Using CAB-1, press ENG, the
locomotive ID# that you select and then
press the SET button located under CAB-1's
removable panel. Hear the horn blow (or
see the headlight flash if RailSounds is off);
that's the Command reverse unit confirm-
ing the new ID#. Set the reverse unit switch
to RUN. Your Interurban Car is ready for
operations with its all-new ID#.
We recommend that you choose an easy to
remember ID# for your engine. Some possi-
bilities are part of the engine road number,
your age, or any two digit number that is not
used by another engine. Write the number on a
small piece of tape and put this on the bottom
of the fuel tank to aid in remembering.
14