Maintenance; Troubleshooting - LifeGear 40115 Owner's Manual

MAINTENANCE

Cleaning
The treadmill can be cleaned with a soft clean damp cloth. Do not use abrasives or
solvents on plastic parts. Please wipe your perspiration off the treadmill after each use.
Be careful not get excessive moisture on the computer display panel as this might cause an
electrical hazard or electronics to fail.
Please keep the treadmill, specially, the computer console, out of direct sunlight to prevent
screen damage.
Please inspect all assembly bolts, nuts, and screws on the machine for proper tightness
every week.

TROUBLESHOOTING

PROBLEM: Treadmill running belt slips or is not centered on rear roller.
SOLUTION: Refer to "Adjusting the Running Belt" section on page 12.
PROBLEM: There is no display on the computer console.
SOLUTION: Remove the computer console and verify the wire that comes from the
computer console is properly connected to the wire that comes from the computer tube.
SOLUTION: Check the batteries are correctly positioned and battery springs are proper
contact with batteries.
SOLUTION: The batteries in the computer console may be dead. Change the new
batteries.
PROBLEM: The treadmill makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the treadmill, please inspect the bolts and tighten
the loose bolts.
13