LifeGear 40115 Owner's Manual page 10

20
4
38
38
39
37
19
19
3
3
Tool:
2
5
Allen Wrench #5
Step 3
Connect the Sensor Wire I (38) from the Computer Tube (4) to the Sensor Wire II (39) from
the Handlebar Support Tube (3).
Attach the Computer Tube (4) into the Handlebar Support Tubes (3) with two M6x12 Bolts
(19). Tighten bolts with the Allen Wrench provided.
Remove the Ø12 Wire Plug (37) from the Computer Tube (4). Connect the Sensor Wire I
(38) from the Computer Tube (4) to the wire that comes from the Computer (20). Tuck wire
into the Computer Tube (4). Install the Ø12 Wire Plug (37) onto the Computer Tube (4)
that was removed.
Hardware:
2 Bolts (M6x12)
9