ZyXEL Communications NXC-8160 User Manual page 46

Chapter 4 WLAN Settings
Table 8 WLAN > ESSID Definition > ESSID Settings (continued)
LABEL
MAC
Authentication
Enable WMM
Beacon Rate
Control
In Band
Management
Captive Portal
VLAN (1-4094)
Disassociation
Timeout (1-
3600)
DTIM
Save
Cancel
Encryption
46
DESCRIPTION
Select this option to authenticate each ESSID connection by using a client
computer's MAC address and an associated RADIUS server. Even if a client
computer does not support 802.1x authentication its connection can still be
authenticated in this manner.
Note: When this option is enabled, the security setting does not
allow you to select any 802.1x method.
Select this option to enable Quality of Service (QoS) data packet filtering based on
whether the data packet traffic is flagged as either video, voice, best effort, or
background. Depending on how data packet is flagged, selecting this option can
have a significant impact on perceived connection speeds.
Select this option if you wish to tune the beacon distribution mechanism. You can
tune the system to provide customized beacon coverage. The higher the rate that
you select, the greater the beacon distribution on this ESSID.
Options are: Basic, Normal, Increased, High, and Full.
Select this option to allow wireless management of the NXC-8160 using other
computers connected to it through this ESSID. In band management ESSIDs must
be on the same VLAN as the switch management VLAN.
Once this option is enabled, the VLAN setting is automatically updated to the same
management VLAN tag ID as set in the LAN > LAN Settings screen.
If enabled, in band management only allows an ESSID to have the following
security settings:
• WPA/WPA2 Personal (TKIP/AES & Pre Shared Key Authentication)
• WPA/WPA2 Enterprise (TKIP/AES & 802.1x Authentication)
Select this option to set this ESSID as "captive portal restricted." If enabled, the
ESSID VLAN tag ID is automatically assigned the same VLAN tag ID as specified in
the Advanced > Portal screen.
A VLAN (Virtual Local Area Network) allows a physical network to be partitioned
into multiple logical networks. Devices on a logical network belong to one group.
Specify a VLAN ID number (between 1 and 4094) to have the ESSID belong to one
VLAN group. Otherwise, leave this field at its default (none).
Enter the duration (in seconds) that a connected computer can remain inactive
(meaning no data is sent to or from said computer) before the NXC-8160
automatically disconnects it from the network.
A DTIM (Delivery Traffic Indication Message) is used to tell the wireless clients in
power-saving mode that a packet is about to be sent to them.Select a DTIM period
(from 1 to 5) (in beacon intervals). This indicates how many broadcast and multicast
packets can be transmitted to wireless clients between two DTIMs.
Click Save to store your changes.
Click Reset to begin configuring this screen afresh.
This section of the screen dynamically changes according to the option you select
in the Method field. For details on this portion of the screen, see
Security Settings and Configuring ESSID Security Settings
About ESSID
in subsequent sections.
NXC-8160 User's Guide