Warranty; S=13、14、15 - LifeSpan GOLD 2.0 Owner's Manual

AUSTRALIAN CONSUMER LAW
Many of our products come with a guarantee or warranty from the manufacturer. In addition, they come with
guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
You are entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure. Full details of your consumer rights may be found at
www.consumerlaw.gov.au
Please visit our website to view our full warranty terms and conditions:
http://www.lifespanonline.com.au/Warranty-Policy
Please email us through
CODE REASON
E01 Message failure between computer
and bottom control board
E02 Burst clash
E03 No sensor signal
E05 Current overload protection
Motor not starting after pressing
START
GOLD 2.0

11. WARRANTY

support@lifespanfitness.com.au
TROUBLE SHOOTING
SOLUTION
1. Check the computer and bottom control board wire
2. Check if IC on bottom control board is loose, reset
3. Power on bottom control board, if there is an error,
1． Check that the power voltage is suitable, if not, use
2． Check if the bottom control is burnt out; if yes -
1． Check that all sensor wires are in good condition,
2． Check the speed sensor, replace if damaged
3． Check the motor condition and wiring
1. Over rated loaded or the motor is stuck, causing
2. Check if there is irregular noise coming from the
Probable Issues:
1.
2.
3.
4.
30
for all warranty or support issues.
connection;
the IC
change the bottom control board
correct power voltage;
replace; then reconnect the motor wire.
replace if damaged
excessive current, machine will start self-protection
system. Adjust the machine and restart;
motor or if the motor / bottom control board is burnt
out; if burnt out, change to a good motor and
bottom control; remember to use the correct
voltage.
Broken motor
Damaged safety wire
Motor wiring not connected well
IGBT on bottom control board is burnt out