Cut-Out Dim. For Es-3112 G/R/C/S/V-Xa Rear Mnt; Figure 3.2:Es-3112 Xa Dimensions Of Cut-Off; Mounting Guide - Advantech ES-3112 G User Manual

3.3 Cut-out Dimensions for ES-3112 G/R/C/S/V-XA
Rear Mounting
To construct a suitable panel, refer to the following cutout & elongated
holes dimension diagram.
Figure 3.2: ES-3112 XA Dimensions of Cut-off.

3.4 Mounting Guide

To mount the ES-3112G/R/C/S/V-XA into a panel or kiosk:
1. Build 8 screw studs along the four sides of the cut out opening based
on the dimension given on the drawing above.
2. There are ten elongated holes located along the four sides of the open
frame monitor. Mount the open frame LCD monitor on by aligning the
screw studs with the elongated hole.
3. Tighten the screw stud with hex nut and make sure it is stable.
Note: The screw stud should not be less than M4 and 5mm in height.
21 Chapter 3