Chapter 2 System Setup
2.1 Introduction
This chapter describes basic features and procedures for using the Open-
frame LCD monitor. Topics covered include the system installation, OSD
control, Touchscreen and so on.
2.2 Preparing for First-time Use
Before you start to set up the ES-3112 LCD Monitor, you should have at
least the following items ready in your accessory box:
• 12 V DC Power adapter
• 2-wire Power cord for adapter
• 1.8 m VGA cable
• 1.8 m RS-232 cable (Not available for ES-3112G)
• CD for ES-3112R/C/S/V s Menu
2.3 I/O Arrangement
The diagram shows the VGA port, RS-232 port and DC Power inlet.
Figure 2.1: Rear View of the ES-3112R/C/S/V
ES-3112 Users Manual
DOWN
UP
AUTO TUNE
PWR.
PWR. LED
10
DC-IN
VGA
COM
MENU