Table of Contents
Advertisement
SELF-TAPPING
BOLT OR SCREW
NOTE: REMOVE ANY PAINT
BELOW RING CONNECTOR
DIA-591
H H 1 1 / / 6 6 W W H H I I T T E E / / B B L L U U E E (-) remote start activation input
Two pulses on this wire within 3-seconds will initiate the start,
or two pulses within 3-seconds will cancel the start. This input
can be wired to a push button switch located in the passenger
compartment or it can be used for diagnostic troubleshooting.
H H 1 1 / / 7 7 L L T T . . G G R R E E E E N N / / B B L L A A C C K K factory alarm disarm
This wire sends a negative pulse every time the remote start is
activated. This can be used to pulse the disarm wire of the
vehicle's factory anti-theft device. Use a relay to send a (-) or (+)
pulse to the disarm factory wire as shown in the following
diagrams.
note: In most instances the negative pulse output can be
connected directly to the factory disarm wire. The circuit
shown on the left below is provided for those instances
where direct connection will not correctly function.
16
GROUND
WIRE
RING
TERMINAL
© 2004 Directed Electronics, Inc.
Advertisement
Table of Contents
