Table of Contents
Advertisement
than one ignition or accessory wire must be energized in
order to operate the climate control system.
➤
The remote start will not activate.
Check harnesses and connections. Make sure the harnesses
are fully plugged into the remote start module. Make sure
there are good connections to the vehicle wiring.
Check voltage and fuses. Use a meter and check for voltage
between the RED wire and the BLACK ground wire. If you
have less than battery voltage, check the and both 30A fuses
on the relay satellite. Also make sure that the ground wire is
going to a good paint-free chassis ground.
➤
The remote start will activate but the starter never engages.
1. Check for voltage on the purple starter wire two seconds
after the remote start becomes active. If there is voltage
present, skip to Step 4. If there is no voltage present, advance
to Step 2.
2. Check the 30A fuses.
3. Make sure the purple starter wire is connected on the
starter side of the optional starter kill relay.
4. Does the vehicle have an immobilizer? Some immobilizer
systems will not allow the vehicle to crank if active.
5. Check connections. The two red heavy gauge input wires
should have solid connections. "T-taps", or "scotch locks"
are not recommended for any high current heavy gauge
wiring. Also, if the vehicle has more than one 12-volt input
wire, then connect one red wire to each.
© 2004 Directed Electronics, Inc.
23
Advertisement
Table of Contents
