Table of Contents
Advertisement
wrap with electrical tape.
F F – – P P I I N N K K / / W W H H I I T T E E (+) output to ignition2/accessory2 circuit
Connect this wire to the second ignition or accessory wire in the
vehicle.
note: For vehicles that do not have a second ignition or
accessory wire, this connection is not required.
note! The WHITE/BLUE (H1/6) wire, (-) remote start
activation input, from the primary harness is used for
testing purposes. Contact Directed Technical Support for
additional information.
l l e e a a r r n n i i n n g g t t r r a a n n s s m m i i t t t t e e r r
The system comes with one transmitter. The receiver can store
up to 4 different transmitter codes in memory. Use the following
to learn the transmitter or to add a transmitter to the system.
The following is the basic sequence of steps to remember whenever
programming this unit:
hold both buttons on the transmitter, until—(see step 3).
3. P P a a r r k k i i n n g g L L i i g g h h t t s s F F l l a a s s h h . . The parking lights will flash twice to
acknowledge programming of this transmitter.
© 2004 Directed Electronics, Inc.
1. K K e e y y . . Turn the ignition to the ON position.
2.
P P r r o o g g r r a a m m . . After 5-seconds, press and
19
Advertisement
Table of Contents
